MPLS-TP Ring Protection Switching (MRPS)
draft-umansky-mpls-tp-ring-protection-switching-03
| Document | Type |
Replaced Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Authors | Igor Umansky , Italo Busi , Huub van Helvoort , Zhang Haiyan , Han Li , Ruiquan Jing | ||
| Last updated | 2011-06-07 (Latest revision 2010-08-23) | ||
| Replaced by | draft-helvoort-mpls-tp-ring-protection-switching | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Replaced by draft-helvoort-mpls-tp-ring-protection-switching | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document describes a mechanism to address the requirements for protection of the Multi-Protocol Label Switching Transport Profile (MPLS-TP) Label Switched Paths (LSP) in a ring topology. The mechanism defined herein is designed to support point-to-point as well as point-to-multipoint LSPs. The MPLS-TP section layer OAM is used to monitor the connectivity between each two adjacent nodes using the mechanisms defined in the [MPLS-TP OAM]. The Automatic Protection Switching (APS) protocol is used for coordination of protection switching actions between the ring nodes.
Authors
Igor Umansky
Italo Busi
Huub van Helvoort
Zhang Haiyan
Han Li
Ruiquan Jing
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)