stateful pce bandwidth scheduling
draft-xiong-pce-stateful-pce-bandwidth-scheduling-01
Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Authors | Quan Xiong , fangwei hu , Ran Chen | ||
Last updated | 2017-06-08 (Latest revision 2016-12-05) | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Expired | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
The Path Computation Element Communication Protocol (PCEP) provides mechanisms for Path Computation Elements (PCEs) to perform path computations in response to Path Computation Clients (PCCs) requests. The stateful PCE extensions allow stateful control of Multi-Protocol Label Switching (MPLS) Traffic Engineering Label Switched Paths (TE LSPs) using PCEP. This document proposes a set of extensions for the stateful PCE, so as to enable bandwidth scheduling for LSP and adjust the bandwidth based on the customers' scheduled bandwidth requirement of a traffic service in a centralized network environment. A bandwidth scheduled LSP can be adjusted to the new bandwidth at its starting time and adjusted back to the original bandwidth at its ending time.
Authors
Quan Xiong
fangwei hu
Ran Chen
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)