SID as source address in SRv6
draft-yang-spring-sid-as-source-address-03
| Document | Type |
This is an older version of an Internet-Draft whose latest revision state is "Replaced".
Expired & archived
|
|
|---|---|---|---|
| Authors | Feng Yang , Changwang Lin | ||
| Last updated | 2024-07-23 (Latest revision 2024-01-18) | ||
| Replaces | draft-yang-spring-srv6-vpn-across-state-firewall | ||
| Replaced by | draft-ietf-spring-sid-as-source-address | ||
| RFC stream | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
In SRv6 network, the SRv6 packets usually use loopback address as source address. However, when there is symmetric traffic requirement for bidirectional flow, or there is requirement for traffic source validation, using loopback address as source address is not sufficient. This document proposes using SID as source address for SRv6 traffic, also identifies solution for several use cases.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)