TRILL Support of Point to Multipoint BFD
draft-zhang-trill-p2mp-bfd-02
| Document | Type | Replaced Internet-Draft (i2rs WG) | |
|---|---|---|---|
| Last updated | 2015-10-14 (latest revision 2015-05-12) | ||
| Replaced by | draft-ietf-trill-p2mp-bfd | ||
| Stream | IETF | ||
| Intended RFC status | (None) | ||
| Formats |
Expired & archived
pdf
htmlized
bibtex
|
||
| Stream | WG state | Adopted by a WG | |
| Document shepherd | No shepherd assigned | ||
| IESG | IESG state | Replaced by draft-ietf-trill-p2mp-bfd | |
| Consensus Boilerplate | Unknown | ||
| Telechat date | |||
| Responsible AD | (None) | ||
| Send notices to | (None) | ||
https://www.ietf.org/archive/id/draft-zhang-trill-p2mp-bfd-02.txt
Abstract
Point to multipoint (P2MP) BFD is designed to verify multipoint connectivity. This document specifies the support of P2MP BFD in TRILL. Similar to TRILL point-to-point BFD, BFD Control packets in TRILL P2MP BFD are transmitted using an RBridge Channel.
Authors
Mingui Zhang
(zhangmingui@huawei.com)
Juniper Networks
(santoshpk@juniper.net)
Vengada Govindan
(venggovi@cisco.com)
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)