RSVP Graceful Setup Procedure
draft-beeram-ccamp-rsvp-graceful-setup-00
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Authors | Vishnu Pavan Beeram , Igor Bryskin | ||
| Last updated | 2014-04-23 (Latest revision 2013-10-20) | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
The GMPLS RSVP-TE setup procedure for transport LSPs outlined in [RFC3473] involves a single iteration signaling sequence. However there are certain scenarios, where it is not feasible to make an LSP fully operational and ready for use via the existing single-step setup procedure. This document proposes a 2-iteration setup procedure for gracefully bringing up transport LSPs in such cases.
Authors
Vishnu Pavan Beeram
Igor Bryskin
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)