Post-Repair Loss RLE Report Block Type for RTCP XR
draft-begen-avt-post-repair-rtcp-xr-01
Document | Type |
Replaced Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Authors | Ali C. Begen , Dong Hsu , Michael Lague | ||
Last updated | 2008-10-06 (Latest revision 2008-05-25) | ||
Replaced by | draft-ietf-avt-post-repair-rtcp-xr | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Replaced by draft-ietf-avt-post-repair-rtcp-xr | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document defines a new report block type within the framework of RTP Control Protocol (RTCP) Extended Reports (XR). One of the initial XR report block types is the Loss Run Length Encoding (RLE) Report Block. This report conveys the information regarding the individual Real-time Transport Protocol (RTP) packet receipt and loss events experienced during the RTCP interval preceding the transmission of the report. The new report, which is referred to as the Post-repair Loss RLE Report, carries the information regarding the remaining lost packets after all error-repair techniques are applied. By comparing the RTP packet receipts/losses before and after the error repair is completed, one can determine the effectiveness of the error-repair techniques in an aggregated fashion. This document also defines the signaling of the Post-repair Loss RLE Report in the Session Description Protocol (SDP).
Authors
Ali C. Begen
Dong Hsu
Michael Lague
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)