Entering IPv6 Zone Identifiers in User Interfaces
draft-carpenter-6man-zone-ui-04
Document | Type |
Replaced Internet-Draft
(6man WG)
Expired & archived
|
|
---|---|---|---|
Authors | Brian E. Carpenter , Bob Hinden | ||
Last updated | 2024-06-27 (Latest revision 2024-03-31) | ||
Replaced by | draft-ietf-6man-zone-ui | ||
RFC stream | Internet Engineering Task Force (IETF) | ||
Intended RFC status | (None) | ||
Formats | |||
Additional resources | Mailing list discussion | ||
Stream | WG state | Adopted by a WG | |
Document shepherd | (None) | ||
IESG | IESG state | Replaced by draft-ietf-6man-zone-ui | |
Consensus boilerplate | Unknown | ||
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document describes how the zone identifier of an IPv6 scoped address, defined in the IPv6 Scoped Address Architecture (RFC 4007), should be entered into a user interface. It obsoletes RFC 6874. Discussion Venue This note is to be removed before publishing as an RFC. Discussion of this document takes place on the 6MAN mailing list (ipv6@ietf.org), which is archived at https://mailarchive.ietf.org/arch/browse/ipv6/ (https://mailarchive.ietf.org/arch/browse/ipv6/).
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)