Skip to main content

Using NETCONF over QUIC connection
draft-dai-netconf-quic-netconf-over-quic-00

The information below is for an old version of the document.
Document Type This is an older version of an Internet-Draft whose latest revision is Active
Authors Jinyou Dai , Xueshun Wang , Yang Kou , Lifen Zhou
Last updated 2021-11-08 (Latest revision 2021-04-25)
Replaces draft-dai-quic-netconf
Stream (None)
Formats
Expired & archived
Stream Stream state (No stream defined)
Consensus boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date (None)
Responsible AD (None)
Send notices to (None)
This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at:
https://www.ietf.org/archive/id/draft-dai-netconf-quic-netconf-over-quic-00.txt

Abstract

The Network Configuration Protocol (NETCONF) provides mechanisms to install, manipulate, and delete the configuration of network devices. At present, almost all implementations of NETCONF are based on TCP based protocol. QUIC, a new UDP-based transport protocol, can facilitate to improve the transportation performance, information security and resource utility when being used as an infrastructure layer of NETCONF. This document describes how to use the QUIC protocol as the transport protocol of NETCONF(It is so called NETCONFoQUIC).

Authors

Jinyou Dai
Xueshun Wang
Yang Kou
Lifen Zhou

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)