IPv6CP Options for PPP Host Configuration
draft-huang-ipv6cp-options-00
Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Author | Jerry Huang | ||
Last updated | 2010-02-03 | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Expired | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
The Softwire Hub and Spoke Framework document outlines three steps for the Softwire Initiator (SI) and PPP peer of the Softwire Concentrator (SC) over IPv4 connectivity to be fully configured for IPv6 once the PPP session has been established. For the same function over IPv6 connectivity, however, only one additional step is needed. This is because IPv6CP only defines the Interface-Identifier option. This document defines additional host configuration options for IPv6CP so that the operational model of IPCP is extended to IPv6CP to reduce requirements on the SI and SC.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)