RTP Payload Format for the Enhanced Variable Rate Wideband Codec (EVRC-WB) and the Media Subtype Updates for EVRC-B Codec
draft-ietf-avt-rtp-evrc-wb-09
Yes
(Cullen Jennings)
No Objection
(David Ward)
(Jari Arkko)
(Jon Peterson)
(Lars Eggert)
(Ron Bonica)
(Ross Callon)
(Russ Housley)
(Sam Hartman)
(Tim Polk)
Note: This ballot was opened for revision 09 and is now closed.
Cullen Jennings Former IESG member
Yes
Yes
()
Unknown
Chris Newman Former IESG member
(was Discuss)
No Objection
No Objection
(2007-11-01)
Unknown
When diffing the media type registrations for audio/EVRCWB and audio/EVRCWB1 I noticed differences due to editorial corrections that were made to one and not the other. Please make all the registrations consistent (e.g., fix typo "in in" and use a proper reference for 3GPP2 C.S0014-C). I question the wisdom of introducing a new storage format here when there is already audio/3gpp2 and video/3gpp2 storage formats. I presume those are container formats (similar to tiff). What is the technical justification for the creation of an incompatible storage format for a subset of the data? Would it perhaps be better to profile audio/3gpp2 to an interoperable subset as we did for tiff fax mode (RFC 3950)?
Dan Romascanu Former IESG member
No Objection
No Objection
(2007-10-31)
Unknown
EVRC should be expanded in the title or in the Abstract session.
David Ward Former IESG member
No Objection
No Objection
()
Unknown
Jari Arkko Former IESG member
No Objection
No Objection
()
Unknown
Jon Peterson Former IESG member
No Objection
No Objection
()
Unknown
Lars Eggert Former IESG member
No Objection
No Objection
()
Unknown
Magnus Westerlund Former IESG member
(was Discuss)
No Objection
No Objection
(2007-10-30)
Unknown
section 9.1.1: maxinterleave: Maximum number for interleaving length (field LLL in the Interleaving Octet). The interleaving lengths used in the entire session MUST NOT exceed this maximum value. If not signaled, the maxinterleave length MUST be 5. I think it would be good if this parameter expressed its valid range. For example: maxinterleave: Maximum number for interleaving length (field LLL in the Interleaving Octet) [0..7]. The interleaving lengths used in the entire session MUST NOT exceed this maximum value. If not signaled, the maxinterleave length MUST be 5.
Ron Bonica Former IESG member
No Objection
No Objection
()
Unknown
Ross Callon Former IESG member
No Objection
No Objection
()
Unknown
Russ Housley Former IESG member
No Objection
No Objection
()
Unknown
Sam Hartman Former IESG member
No Objection
No Objection
()
Unknown
Tim Polk Former IESG member
(was Discuss)
No Objection
No Objection
()
Unknown