LISP YANG Model
draft-ietf-lisp-yang-05

Document Type Active Internet-Draft (lisp WG)
Last updated 2017-07-03
Replaces draft-ermagan-lisp-yang
Stream IETF
Intended RFC status (None)
Formats plain text pdf html bibtex
Yang Validation 0 errors, 106 warnings.
Stream WG state WG Document
Document shepherd No shepherd assigned
IESG IESG state I-D Exists
Consensus Boilerplate Unknown
Telechat date
Responsible AD (None)
Send notices to (None)
LISP Working Group                                            V. Ermagan
Internet-Draft                                        A. Rodriguez-Natal
Intended status: Experimental                                   F. Coras
Expires: January 4, 2018                                       C. Moberg
                                                               R. Rahman
                                                           Cisco Systems
                                                    A. Cabellos-Aparicio
                                       Technical University of Catalonia
                                                                F. Maino
                                                           Cisco Systems
                                                            July 3, 2017

                            LISP YANG Model
                        draft-ietf-lisp-yang-05

Abstract

   This document describes a YANG data model to use with the Locator/ID
   Separation Protocol (LISP).

Status of This Memo

   This Internet-Draft is submitted in full conformance with the
   provisions of BCP 78 and BCP 79.

   Internet-Drafts are working documents of the Internet Engineering
   Task Force (IETF).  Note that other groups may also distribute
   working documents as Internet-Drafts.  The list of current Internet-
   Drafts is at http://datatracker.ietf.org/drafts/current/.

   Internet-Drafts are draft documents valid for a maximum of six months
   and may be updated, replaced, or obsoleted by other documents at any
   time.  It is inappropriate to use Internet-Drafts as reference
   material or to cite them other than as "work in progress."

   This Internet-Draft will expire on January 4, 2018.

Copyright Notice

   Copyright (c) 2017 IETF Trust and the persons identified as the
   document authors.  All rights reserved.

   This document is subject to BCP 78 and the IETF Trust's Legal
   Provisions Relating to IETF Documents
   (http://trustee.ietf.org/license-info) in effect on the date of
   publication of this document.  Please review these documents
   carefully, as they describe your rights and restrictions with respect

Ermagan, et al.          Expires January 4, 2018                [Page 1]
Internet-Draft                  LISP-YANG                      July 2017

   to this document.  Code Components extracted from this document must
   include Simplified BSD License text as described in Section 4.e of
   the Trust Legal Provisions and are provided without warranty as
   described in the Simplified BSD License.

Table of Contents

   1.  Introduction  . . . . . . . . . . . . . . . . . . . . . . . .   2
   2.  LISP Module . . . . . . . . . . . . . . . . . . . . . . . . .   2
     2.1.  Module Structure  . . . . . . . . . . . . . . . . . . . .   3
     2.2.  Module Definition . . . . . . . . . . . . . . . . . . . .   5
   3.  LISP-ITR Module . . . . . . . . . . . . . . . . . . . . . . .  13
     3.1.  Module Structure  . . . . . . . . . . . . . . . . . . . .  13
     3.2.  Module Definition . . . . . . . . . . . . . . . . . . . .  17
   4.  LISP-ETR Module . . . . . . . . . . . . . . . . . . . . . . .  20
     4.1.  Module Structure  . . . . . . . . . . . . . . . . . . . .  20
     4.2.  Module Definition . . . . . . . . . . . . . . . . . . . .  22
   5.  LISP-Map-Server Module  . . . . . . . . . . . . . . . . . . .  26
     5.1.  Module Structure  . . . . . . . . . . . . . . . . . . . .  26
     5.2.  Module Definition . . . . . . . . . . . . . . . . . . . .  32
   6.  LISP-Map-Resolver Module  . . . . . . . . . . . . . . . . . .  37
     6.1.  Module Structure  . . . . . . . . . . . . . . . . . . . .  37
     6.2.  Module Definition . . . . . . . . . . . . . . . . . . . .  38
   7.  LISP-Address-Types Module . . . . . . . . . . . . . . . . . .  39
     7.1.  Module Definition . . . . . . . . . . . . . . . . . . . .  39
   8.  Acknowledgments . . . . . . . . . . . . . . . . . . . . . . .  54
   9.  IANA Considerations . . . . . . . . . . . . . . . . . . . . .  54
   10. Security Considerations . . . . . . . . . . . . . . . . . . .  54
   11. Normative References  . . . . . . . . . . . . . . . . . . . .  54
   Authors' Addresses  . . . . . . . . . . . . . . . . . . . . . . .  55

1.  Introduction

   The Locator/ID Separation Protocol (LISP) defines several network
   elements subject to be configured.  This document presents the YANG
   data models required for basic configuration of all major LISP
   [RFC6830]elements.  The models also capture some essential
   operational data elements as well.

2.  LISP Module

   This module is the base LISP module that is augmented in multiple
   models to represent various LISP device roles.

Ermagan, et al.          Expires January 4, 2018                [Page 2]
Show full document text