Packet Loss and Delay Measurement for the MPLS Transport Profile
draft-ietf-mpls-tp-loss-delay-00
Document | Type | Replaced Internet-Draft (mpls WG) | |
---|---|---|---|
Authors | Dan Frost , Stewart Bryant | ||
Last updated | 2011-01-24 (latest revision 2010-07-26) | ||
Replaces | draft-frost-mpls-tp-loss-delay | ||
Replaced by | RFC 6375 | ||
Stream | Internent Engineering Task Force (IETF) | ||
Intended RFC status | (None) | ||
Formats |
Expired & archived
pdf
htmlized (tools)
htmlized
bibtex
|
||
Stream | WG state | WG Document | |
Document shepherd | No shepherd assigned | ||
IESG | IESG state | Replaced by draft-ietf-mpls-tp-loss-delay-profile | |
Consensus Boilerplate | Unknown | ||
Telechat date | |||
Responsible AD | (None) | ||
Send notices to | (None) |
https://www.ietf.org/archive/id/draft-ietf-mpls-tp-loss-delay-00.txt
Abstract
An essential Operations, Administration and Maintenance requirement of the MPLS Transport Profile (MPLS-TP) is the ability to monitor performance metrics for packet loss and one-way and two-way delay for MPLS-TP pseudowires, Label Switched Paths, and Sections. This document specifies protocol mechanisms to facilitate the efficient and accurate measurement of these performance metrics.
Authors
Dan Frost
(danfrost@cisco.com)
Stewart Bryant
(stbryant@cisco.com)
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)