RADIUS Attributes for Multilink PPP Banwidth Allocation Control

Document Type Expired Internet-Draft (radius WG)
Author Glen Zorn 
Last updated 1998-02-16 (latest revision 1998-08-14)
Stream Internet Engineering Task Force (IETF)
Intended RFC status (None)
Expired & archived
plain text pdf htmlized bibtex
Stream WG state WG Document
Document shepherd No shepherd assigned
IESG IESG state Expired
Consensus Boilerplate Unknown
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at


This document describes a set of vendor-specific RADIUS attributes designed to support the dynamic control of bandwidth allocation in mul- tilink PPP [1]. Attributes are defined that specify whether use of the PPP Bandwidth Allocation Protocol [2] is allowed or required on incoming calls, the level of line capacity (expressed as a percentage) below which utilization must fall before a link is eligible to be dropped, and the length of time (in seconds) that a link must be underutilized before it is dropped.


Glen Zorn (glenzorn@hotmail.com)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)