Service Provider Requirements for Ethernet control with GMPLS
draft-imajuku-ccamp-ethernet-gmpls-req-01
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Author | Wataru Imajuku | ||
| Last updated | 2007-11-20 | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
Generalized Multi-Protocol Label Switching (GMPLS) is applicable to Ethernet switches supporting Provider Backbone Bridge Traffic Engineering (PBB-TE) networks. The GMPLS controlled Ethernet label switch network not only automates creation of Ethernet Label Switched Paths(Eth-LSPs), it also provides sophisticated Eth-LSP recovery Mechanisms such as protection and restoration of an Eth-LSP. This document describes the requirements for the set of solutions of GMPLS controlled Ethernet label switch networks.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)