BASE (Billing- and Accounting-System Exchange-Protocol) Protocol Specification
draft-ioag-base-01
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Authors | Odo Maletzki , Thilo Dieckmann , Martin Grundmann | ||
| Last updated | 2000-04-28 | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
The Billing and Accounting System Exchange (BASE) protocol is intended for use for the data transfer between the subsystems of a distributed billing and accounting system. It defines the communication between central billing engines (BEs) and one or more locally or remotely installed billing agents (BAs). BAs are used to supply the BEs with load data used for billing and accounting purposes. BEs are responsible for the process of billing and accounting as well as for the configuration of the BAs and their connected source systems. This document defines and describes the BASE protocol.
Authors
Odo Maletzki
Thilo Dieckmann
Martin Grundmann
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)