RSVP-TE Extension for IPv4/IPv6 Dual Stacking PE under IPv4 MPLS Core Environment
draft-ishii-rsvp-te-ipv4-ipv6-extension-00
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Author | Hideo Ishii | ||
| Last updated | 2002-02-22 | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document specifies a method to establish Label Switch Paths (LSPs) for IPv4 and IPv6 traffic interminglement over IPv4 MPLS network using [RSVP-TE]. IP version(s) of traffic to be transmitted over the established LSP can be recognized by egress routers using new SESSION_ATTRIBUTE type. IPv4 Label Switch Routers (LSRs) are not required to have knowledge about the Provider Edge (RE) Routers which support this extension
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)