IPv6 Stateless Address Autoconfiguration
draft-jinmei-ipv6-rfc2462bis-00
Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Author | Dr. Susan Thomson | ||
Last updated | 2003-10-27 | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Expired | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document specifies the steps a host takes in deciding how to autoconfigure its interfaces in IP version 6. The autoconfiguration process includes creating a link-local address and verifying its uniqueness on a link, determining what information should be autoconfigured (addresses, other information, or both), and in the case of addresses, whether they should be obtained through the stateless mechanism, the stateful mechanism, or both. This document defines the process for generating a link-local address, the process for generating site-local and global addresses via stateless address autoconfiguration, and the Duplicate Address Detection procedure. The details of autoconfiguration using the stateful protocol are specified elsewhere.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)