Skip to main content

Diameter Command Codes for Third Generation Partnership Project (3GPP) Release 5

The information below is for an old version of the document that is already published as an RFC.
Document Type
This is an older version of an Internet-Draft that was ultimately published as RFC 3589.
Author John A. Loughney
Last updated 2020-01-21 (Latest revision 2002-12-04)
RFC stream Independent Submission
Stream ISE state (None)
Consensus boilerplate Unknown
Document shepherd (None)
IESG IESG state RFC 3589 (Informational)
Telechat date (None)
Responsible AD Randy Bush
Send notices to (None)
A new Request for Comments is now available in online RFC libraries.

        RFC 3589

        Title:      Diameter Command Codes for Third Generation
                    Partnership Project (3GPP) Release 5
        Author(s):  J. Loughney
        Status:     Informational
        Date:       September 2003
        Pages:      5
        Characters: 8010
        Updates/Obsoletes/SeeAlso:    None

        I-D Tag:    draft-loughney-aaa-cc-3gpp-01.txt


This document describes the IANA's allocation of a block of Diameter
Command Codes for the Third Generation Partnership Project (3GPP)
Release 5.  This document does not pass judgment on the usage of these
command codes.  Further more, these command codes are for use for
Release 5.  For future releases, these codes cannot be reused, but
must be allocated according to the Diameter Base specification.

This memo provides information for the Internet community.  It does
not specify an Internet standard of any kind.  Distribution of this
memo is unlimited.

This announcement is sent to the IETF list and the RFC-DIST list.
Requests to be added to or deleted from the IETF distribution list
should be sent to IETF-REQUEST@IETF.ORG.  Requests to be
added to or deleted from the RFC-DIST distribution list should

Details on obtaining RFCs via FTP or EMAIL may be obtained by sending
an EMAIL message to rfc-info@RFC-EDITOR.ORG with the message body 
help: ways_to_get_rfcs.  For example:

        To: rfc-info@RFC-EDITOR.ORG
        Subject: getting rfcs

        help: ways_to_get_rfcs

Requests for special distribution should be addressed to either the
author of the RFC in question, or to RFC-Manager@RFC-EDITOR.ORG.  Unless
specifically noted otherwise on the RFC itself, all RFCs are for
unlimited distribution.echo 
Submissions for Requests for Comments should be sent to
RFC-EDITOR@RFC-EDITOR.ORG.  Please consult RFC 2223, Instructions to RFC
Authors, for further information.