Mobile IPv6 Regional Forwarding
draft-malinen-mobileip-reg6fwd-00

Document Type Expired Internet-Draft (individual)
Authors Jare Malinen  , Charles Perkins 
Last updated 2001-03-08
Stream (None)
Intended RFC status (None)
Formats
Expired & archived
pdf htmlized (tools) htmlized bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-malinen-mobileip-reg6fwd-00.txt

Abstract

Data forwarding to a Mobile IPv6 mobile node employs either encapsulation or routing header -based forwarding, latter when using route optimization. Forwarding through a domain with hierarchical extensions to Mobile IPv6 by default uses encapsulation to pass route-optimized packets over the last hop to the mobile node. However, it is highly desirable to avoid the overhead of sending an extra 40 byte encapsulation header per packet over the last hop. This document describes Mobile IPv6 regional forwarding which is an optional optimized data forwarding method. It avoids the encapsulation header and can be used e.g. with Mobile IPv6 Regional Registrations.

Authors

Jare Malinen (jari.t.malinen@nokia.com)
Charles Perkins (charliep@computer.org)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)