MPLS for SDH control
draft-mannie-mpls-sdh-control-00
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Author | Eric Mannie | ||
| Last updated | 2000-03-03 | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document is an attempt to specify how MPLS could be used to control the establishment of SDH paths. It identifies the elements that could be switched in SDH, proposes a way to build labels for SDH 'intelligent' switching and discusses several problems. Annexes A and B are intended to specify how to support this specification using CR-LDP and TE-RSVP.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)