SA46T Prefix Resolution (SA46T-PR)
draft-matsuhira-sa46t-pr-spec-02
The information below is for an old version of the document.
Document | Type |
This is an older version of an Internet-Draft whose latest revision state is "Expired".
Expired & archived
|
|
---|---|---|---|
Author | Naoki Matsuhira | ||
Last updated | 2014-07-21 (Latest revision 2014-01-07) | ||
RFC stream | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Expired | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document specifies SA46T Prefix Resolution (SA46T-PR) specification. SA46T-PR is almost same as SA46T, however method of generation of outer IPv6 address is different. SA46T is backbone network based approach, however SA46T-PR is stub network based approch.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)