Performance Measurement with Asymmetrical Packets in STAMP
draft-mirsky-ippm-asymmetrical-pkts-04
| Document | Type |
Replaced Internet-Draft
(ippm WG)
Expired & archived
|
|
|---|---|---|---|
| Authors | Greg Mirsky , Ernesto Ruffini , Henrik Nydell , Richard "Footer" Foote | ||
| Last updated | 2024-04-30 (Latest revision 2024-02-20) | ||
| Replaced by | draft-ietf-ippm-asymmetrical-pkts | ||
| RFC stream | Internet Engineering Task Force (IETF) | ||
| Intended RFC status | Proposed Standard | ||
| Formats | |||
| Additional resources | Mailing list discussion | ||
| Stream | WG state | Adopted by a WG | |
| Document shepherd | (None) | ||
| IESG | IESG state | Replaced by draft-ietf-ippm-asymmetrical-pkts | |
| Consensus boilerplate | Yes | ||
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document describes an optional extension to a Simple Two-way Active Measurement Protocol (STAMP) that enables the use of STAMP test and reflected packets of variable length during a single STAMP test session. In some use cases, the use of asymmetrical test packets allow for the creation of more realistic flows of test packets and, thus, a closer approximation between active performance measurements and conditions experienced by the monitored application. Also, the document includes an analysis of challenges related to performance monitoring in a multicast network. It defines procedures and STAMP extensions to achieve more efficient measurements with a lesser impact on a network.
Authors
Greg Mirsky
Ernesto Ruffini
Henrik Nydell
Richard "Footer" Foote
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)