Skip to main content

Multihoming L3 Shim Approach

Document Type Expired Internet-Draft (individual)
Authors Erik Nordmark , Marcelo Bagnulo
Last updated 2004-10-18
Stream (None)
Expired & archived
Stream Stream state (No stream defined)
Consensus boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date (None)
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:


This document outlines an approach to solving IPv6 multihoming in order to stimulate discussion. The approach is based on using a multi6 shim placed between the IP endpoint sublayer and the IP routing sublayer, and, at least initially, using routable IP locators as the identifiers visible above the shim layer. The approach does not introduce a "stack name" type of identifier, instead it ensures that all upper layer protocols can operate unmodified in a multihomed setting while still seeing a stable IPv6 address. This document does not specify the mechanism for authenticating and authorizing the "rehoming" - this is specified in the HBA document. Nor does it specify the messages used to establish multihoming state. The document does not even specify the packet format used for the data packets. Instead it discusses the issue of receive side demultiplexing and the different tradeoffs. The resolution of this issue will effect the packet format for the data packets.


Erik Nordmark
Marcelo Bagnulo

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)