IP Mobility Support with IP-squared(IP2)
draft-okanoue-mobileip-ipsquared-00
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Authors | Kazuhiro Okanoue , Tomoki Ohsawa | ||
| Last updated | 1996-02-22 | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document specifies an encapsulation method for mobile-IP which enables intermediate systems to initiate routing optimization process. Key mechanism is to concatenation IP header as an outer IP header instead of IP tunneling specified as protocol number 4 in [1]. This datagram is called IP2 (IP squared) datagram. In order to handle the datagram, it is required for every mobility supporting node to have two functionalities, which discriminate whether received datagram is IP or IP2 datagrams and decide which datagram format should be used as transmitting datagram IP or IP2. These functionalities enable an intermediate mobility support node to initiate routing optimization process in [2] and routing paths between mobile and conventional stationary nodes can be optimized in the result.
Authors
Kazuhiro Okanoue
Tomoki Ohsawa
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)