Setup and Maintenance of Pseudowires using RSVP-TE
draft-raggarwa-rsvpte-pw-03
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Author | Rahul Aggarwal | ||
| Last updated | 2005-10-26 | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document describes procedures for using Resource Reservation Protocol-Traffic Engineering (RSVP-TE) for signaling Pseudowires (PWs). One motivation is the signaling of PW QoS. The other is the setup of a multi-hop PW, for example, to span multiple domains. RSVP-TE provides mechanisms for QoS signaling and these can be leveraged for signaling PW QoS. It also provides the ability to signal bi-directional MPLS Label Switched Paths (LSP) with explicit routes. This can be used for signaling multi-hop PWs that require explicit routing. RSVP-TE also provides the ability to establish non- adjacent or targeted signaling sessions.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)