Header compression and multiplexing in LISP
draft-saldana-lisp-compress-mux-00
| Document | Type |
This is an older version of an Internet-Draft whose latest revision state is "Expired".
Expired & archived
|
|
|---|---|---|---|
| Authors | Jose Saldana , Julian Fernandez Navajas , Jose Ruiz Mas | ||
| Last updated | 2016-11-14 (Latest revision 2016-05-04) | ||
| RFC stream | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
When small payloads are transmitted through a packet-switched network, the resulting overhead may result significant. This is stressed in the case of LISP, where a number of headers are prepended to a packet, as new headers have to be added to each packet. This document proposes to send together a number of small packets, which are in the buffer of a ITR, having the same ETR as destination, into a single packet. Therefore, they will share a single LISP header, and therefore bandwidth savings can be obtained, and a reduction in the overall number of packets sent to the network can be achieved.
Authors
Jose Saldana
Julian Fernandez Navajas
Jose Ruiz Mas
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)