Skip to main content

Multicast Support for NAT64
draft-sarikaya-behave-mcast4nat64-05

The information below is for an old version of the document.
Document Type
This is an older version of an Internet-Draft whose latest revision state is "Expired".
Expired & archived
Authors Behcet Sarikaya , Teemu Kiviniemi
Last updated 2012-07-13 (Latest revision 2012-01-10)
RFC stream (None)
Formats
Stream Stream state (No stream defined)
Consensus boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date (None)
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:

Abstract

This memo specifies modifications required to NAT64 so that IPv6 only hosts can receive multicast data from IPv4 only servers. The protocol is based on translating IPv4 multicast data before delivering it to the host in IPv6. The protocol also allows IPv6 only host to join IPv4 any source/ source specific multicast group in IPv6 using Multicast Listener Discovery protocol.

Authors

Behcet Sarikaya
Teemu Kiviniemi

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)