Skip to main content

Packet Delay Measurement for SFC
draft-sfc-agv-packet-delay-measurement-00

Document Type Replaced Internet-Draft (individual)
Expired & archived
Author Gaurav Agrawal
Last updated 2015-12-11
Replaced by draft-agv-sfc-packet-delay-measurement
RFC stream (None)
Intended RFC status (None)
Formats
Stream Stream state (No stream defined)
Consensus boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Replaced by draft-agv-sfc-packet-delay-measurement
Telechat date (None)
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:

Abstract

Service provider service level agreements (SLAs) depend on the capability to measure and monitor performance metrics for packet Delay. The common reasons for packet delay are Nodal processing(Algorithmic, Packetization etc...), Queuing, Transmission delay, Propagation delay and Service Function processing delay. Packet Delay Measurement capability also provides operators with greater visibility into the performance characteristics of their networks, thereby facilitating planning, troubleshooting, and network performance evaluation. This document specifies best possible efficient and accurate mechanism for passive packet delay measurement for Service Function Chains (SFCs) for a SFC network domain.

Authors

Gaurav Agrawal

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)