IP Link Model for MANET
draft-singh-autoconf-linkmodel-00
| Document | Type |
Withdrawn by Submitter Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Authors | Shubhranshu Singh , Ashutosh Bhatia | ||
| Last updated | 2008-08-21 | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Withdrawn by Submitter | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
The stateless as well as stateful address autoconfiguration Protocols, as specified by the IETF, supports links with different properties. However, often these protocols assume specific properties and behavior from the underlying link type, as for example link-layer multicasting. The solution designer and implementers consider these specific link behavior while designing or extending these protocols. IETF Autoconf WG goal is to standardize mechanism for address autoconfiguration of nodes in a Mobile Ad Hoc Network (MANET). Before designing such protocol, the link model for MANET as seen by the IP needs to be clearly understood . However, there is no document describing IP link model for MANET. This document is an attempt to bridge this gap.
Authors
Shubhranshu Singh
Ashutosh Bhatia
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)