Skip to main content

Conveying path setup type in PCEP messages
draft-sivabalan-pce-lsp-setup-type-01

The information below is for an old version of the document.
Document Type This is an older version of an Internet-Draft whose latest revision is Replaced
Authors Siva Sivabalan , Jan Medved , Ina Minei , Edward Crabbe
Last updated 2014-04-19 (Latest revision 2013-10-16)
Replaced by draft-ietf-pce-lsp-setup-type, draft-ietf-pce-lsp-setup-type
Stream (None)
Formats
Expired & archived
Stream Stream state (No stream defined)
Consensus boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date (None)
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:

Abstract

A Path Computation Element can compute traffic engineering paths (TE paths) through a network that are subject to various constraints. Currently, TE paths are label switched paths (LSPs) which are set up using the RSVP-TE signaling protocol. However, other TE path setup methods are possible within the PCE architecture. This document proposes an extension to PCEP to allow support for different path setup methods over a given PCEP session.

Authors

Siva Sivabalan
Jan Medved
Ina Minei
Edward Crabbe

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)