IPPM measurement signature
draft-stephan-ippm-test-packet-header-01
Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Author | Emile Stephan | ||
Last updated | 2002-11-04 | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Expired | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
Despite the growing availability of good measurement platforms, it is still impossible to generalize IPPM metrics measurement among heterogeneous points of measure. To do so, the extra information inserted in the IP packets to perform the measurement has to be standardized. This document defines an IPPM measurement signature suitable for performing the measure of the current IPPM metrics, for integrating those used by manufacturers and for allowing the IPPM WG to define other measurement signature in the future.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)