Name-Based Sockets Architecture
draft-ubillos-name-based-sockets-03
Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Authors | Javier Ubillos , Mingwei Xu , Zhongxing Ming , Christian Vogt | ||
Last updated | 2010-09-17 | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Expired | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This memo defines Name-based sockets. name-based sockets allow application developers to refer to remote hosts (and it self) by name only, passing on all IP (locator) management to the operating system. Applications are thus relieved of re-implementing features such as multi-homing, mobility, NAT traversal, IPv6/IPv4 interoperability and address management in general. The operating system can in turn re- use the same solutions for a whole set of guest applications. name- based sockets aims to provide a whole set of features without adding new indirection layers, new delays or other dependences while maintaining transparent backwards compatibility.
Authors
Javier Ubillos
Mingwei Xu
Zhongxing Ming
Christian Vogt
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)