A routing method based on detection frames over LLNs
draft-wei-roll-rmdf-00
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Author | Anni Wei | ||
| Last updated | 2009-08-07 | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document presents a routing method through sending detection frames including address of destination node to the neighbor nodes to reduce delay of data transmission because of the dormant nodes will increase data transmission delay in low power and lossy networks(LLNs). When receives the response from the neighbor nodes, the sending node can select a neighboring node as the next hop node to sent data, which has the lower cost parameter than the cost parameter between the sending node and the destination node stored in the routing table of sending node. This routing method finds a route in real-time by broadcasting detection frames. As long as any neighbor node that can reach the destination is active, data can be sent and then the data transmission delay will be reduced.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)