Learning the IPv6 Prefix of a Network's IPv6/IPv4 Translator
draft-wing-behave-learn-prefix-04
Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Author | Dan Wing | ||
Last updated | 2009-10-26 | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Expired | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
Some IPv6 applications obtain IPv4 address literals and want to communicate with those IPv4 hosts through an IPv6/IPv4 translator. The IPv6 application can send an IPv6 packet through the translator if it knows the IPv6 prefix of the IPv6/IPv4 translator. In many IPv6/IPv4 translation deployments, that IPv6 prefix is not fixed; rather, the prefix is chosen by the network operator. This specification provides three methods for a host to learn the IPv6 prefix of its IPv6/IPv4 translator. Unicast, any-source multicast (ASM), and source-specific multicast (SSM) are supported.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)