Attribute-Value Pairs For Provisioning Customer Equipment Supporting IPv4-Over-IPv6 Transitional Solutions
draft-zhou-dime-4over6-provisioning-02

The information below is for an old version of the document
Document Type Expired Internet-Draft (individual)
Authors Cathy Zhou  , Tom Taylor  , Qiong Sun  , Mohamed Boucadair 
Last updated 2014-04-24 (latest revision 2013-10-21)
Stream (None)
Formats
Expired & archived
plain text xml pdf htmlized bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-zhou-dime-4over6-provisioning-02.txt

Abstract

During the transition from IPv4 to IPv6, customer equipment may have to support one of the various transition methods that have been or are currently being defined for carrying IPv4 packets over IPv6. Work is currently in progress to enumerate the information that needs to be provisioned on a customer edge router to support a list of transition techniques based on tunneling IPv4 in IPv6, with a view to defining reusable components for a reasonable transition path between these techniques. To the extent that the provisioning is done dynamically, AAA support is needed to provide the information to the network server responsible for passing the information to the customer equipment. This document specifies Diameter attribute-value pairs to be used for that purpose.

Authors

Cathy Zhou (cathy.zhou@huawei.com)
Tom Taylor (tom.taylor.stds@gmail.com)
Qiong Sun (sunqiong@ctbri.com.cn)
Mohamed Boucadair (mohamed.boucadair@orange.com)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)