RFC 1298

Document Type RFC - Informational (February 1992; No errata)
Obsoleted by RFC 1420
Last updated 2013-03-02
Stream IETF
Formats plain text pdf html bibtex
Stream WG state (None)
Document shepherd No shepherd assigned
IESG IESG state RFC 1298 (Informational)
Consensus Boilerplate Unknown
Telechat date
Responsible AD (None)
Send notices to (None)
Network Working Group                                         R. Wormley
Request for Comments: 1298                                    S. Bostock
                                                            Novell, Inc.
                                                           February 1992

                             SNMP over IPX

Status of this Memo

   This memo provides information for the Internet community.  It does
   not specify an Internet standard.  Distribution of this memo is


   This memo defines a convention for encapsulating Simple Network
   Management Protocol (SNMP) [1] packets over the transport mechanism
   provided via the Internetwork Packet Exchange (IPX) protocol [2].

Editor's Note

   As stated below and in reference [5], it is strongly advised that for
   interoperability, SNMP be implemented over UDP/IP and not directly on
   media or other protocols (such as IPX).

1.  Introduction

   The SNMP protocol has been specified as the official network
   management protocol of the Internet.  Its widespread acceptance and
   implementation by developers, both inside and outside the Internet
   community, is fostering synergetic growth to a variety of protocols
   and platforms.

   This memo addresses the use of SNMP over the IPX protocol, which has
   become quite widespread principally due to the popularity of Novell
   NetWare.  Roughly equivalent to UDP in function, IPX provides
   connectionless, unacknowledged datagram service over a variety of
   physical media and protocols.

   Although modifications have been made elsewhere in the NetWare
   protocol suite, IPX is identical to the Xerox Internet Datagram
   Protocol (IDP) [3].  The socket address space authority is
   administered by Novell.

   The use of SNMP over the UDP transport [4] is today the common mode
   of operation in the Internet. This specification may be appropriate
   for some environments in which UDP transport services are not

Wormley & Bostock                                               [Page 1]
RFC 1298                     SNMP over IPX                 February 1992

   available.  SNMP implementors should be aware that the choice of
   underlying transport may have a significant impact on the
   interoperability and ubiquity of the management capability in the
   Internet.  Considerations relevant to choosing a transport for use
   with SNMP are described in [5].

2.  Specification

   SNMP packets will always set the Packet Type field in the IPX header
   to 4 (i.e., Packet Exchange Packet).

2.1  Socket Assignments

   SNMP protocol entities will receive GetRequest-PDU, GetNextRequest-
   PDU, and SetRequest-PDU messages on socket 36879 (Destination Socket
   field set to hexadecimal 900F), and Trap-PDU messages on socket 36880
   (Destination Socket field set to hexadecimal 9010).

   GetResponse-PDU messages will be addressed to the IPX address and
   socket from which the corresponding GetRequest-PDU, GetNextRequest-
   PDU, or SetRequest-PDU originated.

2.2  Maximum Packet Length

   Although SNMP does not require conformant implementations to accept
   messages whose length exceed 484 bytes, it is recommended that
   implementations support a maximum SNMP message size of 546 bytes (the
   maximum size allowed under IPX).  Furthermore, this limit is the
   maximum packet length guaranteed to traverse IPX routers which do not
   provide fragmentation.  Implementors may choose to use longer packet
   lengths if the maximum is known, which depends on the intermediate
   routers and/or intermediate datalink layer protocols.

2.3  The agent-addr Field for the Trap-PDU

   The agent-addr field in a Trap-PDU emitted by an SNMP agent should
   contain the IpAddress  An SNMP manager may ascertain the
   source of the trap by querying the transport layer.

2.4  IPX Transport Address Representation

   There are occasions when it is necessary to represent a transport
   service address in a MIB.  For instance, the SNMP party MIB [6] uses
   an OBJECT IDENTIFIER to define the transport domain (IP, IPX, etc.)
   and an OCTET STRING to represent an address within that domain.  The
   following definitions are provided for use in such a scheme.

Wormley & Bostock                                               [Page 2]
RFC 1298                     SNMP over IPX                 February 1992


      enterprises         FROM RFC1155-SMI;

      novell              OBJECT IDENTIFIER ::= { enterprises 23 }
      transportDomains    OBJECT IDENTIFIER ::= { novell 7 }

      ipxTransportDomain  OBJECT IDENTIFIER ::= { transportDomains 1 }

    -- Authoritatively names the IPX Transport Domain

    IpxTransportAddress ::= OCTET STRING (SIZE (12))

    -- A textual convention denoting a transport service address in
    -- the ipxTransportDomain.  An IpxTransportAddress is 12 octets
    -- long and comprises 3 fields, each in network-byte (high-low)
Show full document text