Quick-Start for TCP and IP
draft-amit-quick-start-04
Document | Type |
Expired Internet-Draft
(individual in tsv area)
Expired & archived
|
|
---|---|---|---|
Authors | Amit Jain , Sally Floyd | ||
Last updated | 2015-10-14 (Latest revision 2005-02-22) | ||
RFC stream | Internet Engineering Task Force (IETF) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | WG state | (None) | |
Document shepherd | (None) | ||
IESG | IESG state | Expired (IESG: Dead) | |
Action Holders |
(None)
|
||
Consensus boilerplate | Unknown | ||
Telechat date | (None) | ||
Responsible AD | Allison J. Mankin | ||
IESG note | |||
Send notices to | pasi.sarolahti@iki.fi, jon.peterson@neustar.biz, mallman@icir.org |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This draft specifies an optional Quick-Start mechanism for transport protocols, in cooperation with routers, to determine an allowed sending rate at the start and at times in the middle of a data transfer. While Quick-Start is designed to be used by a range of transport protocols, in this document we describe its use with TCP. By using Quick-Start, a TCP host, say, host A, would indicate its desired sending rate in bytes per second, using a Quick Start Request option in the IP header of a TCP packet. A Quick-Start request for a higher sending rate would be sent in a TCP packet. Each router along the path could, in turn, either approve the requested rate, reduce the requested rate, or indicate that the Quick-Start request is not approved. If the Quick-Start request is not approved, then the sender would use the default congestion control mechanisms. The Quick-Start mechanism can determine if there are routers along the path that do not understand the Quick- Start Request option, or have not agreed to the Quick-Start rate request. TCP host B communicates the final rate request to TCP host A in a transport-level Quick-Start Response in an answering TCP packet. Quick-Start is designed to allow connections to use higher sending rates when there is significant unused bandwidth along the path, and all of the routers along the path support the Quick-Start Request.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)