Skip to main content

LDP Extensions for RMR
draft-ietf-mpls-ldp-rmr-extensions-03

Document Type Expired Internet-Draft (mpls WG)
Expired & archived
Authors Santosh Esale , Kireeti Kompella
Last updated 2023-10-22 (Latest revision 2020-03-09)
Replaces draft-esale-mpls-ldp-rmr-extensions
RFC stream Internet Engineering Task Force (IETF)
Intended RFC status (None)
Formats
Additional resources Mailing list discussion
Stream WG state WG Document
Document shepherd (None)
IESG IESG state Expired
Consensus boilerplate Unknown
Telechat date (None)
Responsible AD (None)
Send notices to Loa Andersson <loa@pi.nu>

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:

Abstract

This document describes LDP extensions to signal Resilient MPLS Ring (RMR) Label Switched Paths (LSPs). An RMR LSP is a multipoint to point LSP signaled using LDP (Label Distribution Protocol). RMR Architecture document - draft-ietf-mpls-rmr-02 - describes why and how MPLS should be used in ring topologies.

Authors

Santosh Esale
Kireeti Kompella

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)