Skip to main content

Seamless MPLS Architecture

Document Type Expired Internet-Draft (mpls WG)
Expired & archived
Authors Nicolai Leymann , Bruno Decraene , Clarence Filsfils , Maciek Konstantynowicz , Dirk Steinberg
Last updated 2015-10-14 (Latest revision 2014-06-28)
Replaces draft-leymann-mpls-seamless-mpls
RFC stream Internet Engineering Task Force (IETF)
Intended RFC status Informational
Additional resources Mailing list discussion
Stream WG state Submitted to IESG for Publication
Revised I-D Needed - Issue raised by AD
Associated WG milestone
Jun 2015
Submit draft-ietf-mpls-seamless-mpls for publication
Document shepherd Loa Andersson
Shepherd write-up Show Last changed 2014-09-30
IESG IESG state Expired (IESG: Dead)
Action Holders
Consensus boilerplate Unknown
Telechat date (None)
Responsible AD Deborah Brungard
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:


This documents describes an architecture which can be used to extend MPLS networks to integrate access and aggregation networks into a single MPLS domain ("Seamless MPLS"). The Seamless MPLS approach is based on existing and well known protocols. It provides a highly flexible and a scalable architecture and the possibility to integrate 100.000 of nodes. The separation of the service and transport plane is one of the key elements; Seamless MPLS provides end to end service independent transport. Therefore it removes the need for service specific configurations in network transport nodes (without end to end transport MPLS, some additional services nodes/configurations would be required to glue each transport domain). This draft defines a routing architecture using existing standardized protocols. It does not invent any new protocols or defines extensions to existing protocols.


Nicolai Leymann
Bruno Decraene
Clarence Filsfils
Maciek Konstantynowicz
Dirk Steinberg

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)