PIM Join/ Prune Attributes for LISP Environments using Underlay Multicast
draft-ietf-pim-jp-extensions-lisp-03
| Document | Type |
This is an older version of an Internet-Draft whose latest revision state is "Active".
Expired & archived
|
|
|---|---|---|---|
| Authors | Vengada Prasad Govindan , Stig Venaas | ||
| Last updated | 2023-10-04 (Latest revision 2023-04-02) | ||
| Replaces | draft-vgovindan-pim-jp-extensions-lisp | ||
| RFC stream | Internet Engineering Task Force (IETF) | ||
| Formats | |||
| Additional resources | Mailing list discussion | ||
| Stream | WG state | WG Document | |
| Document shepherd | (None) | ||
| IESG | IESG state | Expired | |
| Consensus boilerplate | Unknown | ||
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document specifies an extension to PIM Receiver RLOC Join/ Prune attribute that supports the construction of multicast distribution trees where the root and receivers are located in different Locator/ ID Separation Protocol (LISP) sites and are connected using underlay IP Multicast. This attribute allows the receiver site to signal the underlay multicast group to the control plane of the root ITR (Ingress Tunnel Router).
Authors
Vengada Prasad Govindan
Stig Venaas
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)