MPL Forwarder Select (MPLFS)
draft-ietf-roll-mpl-forw-select-00
Document | Type |
Expired Internet-Draft
(roll WG)
Expired & archived
|
|
---|---|---|---|
Authors | Peter Van der Stok , Abdur Rashid Sangi | ||
Last updated | 2017-06-10 (Latest revision 2016-12-07) | ||
Replaces | draft-vanderstok-roll-mpl-forw-select | ||
RFC stream | Internet Engineering Task Force (IETF) | ||
Intended RFC status | (None) | ||
Formats | |||
Additional resources | Mailing list discussion | ||
Stream | WG state | WG Document | |
Document shepherd | (None) | ||
IESG | IESG state | Expired | |
Consensus boilerplate | Unknown | ||
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document describes a Forwarder Selection (MPLFS) protocol for the Multicast Protocol for Low-Power and lossy Networks (MPL) to reduce the density of forwarders such that the number of forwarded messages is reduced. The protocol uses Trickle to distribute link-local information about the identity of the neighbours of the nodes that have MPL-enabled interfaces. In the end-state all nodes are connected to a minimum number, N_DUPLICATE, of forwarders, where N_DUPLICATE is application dependent, and there is a path between any two forwarders.
Authors
Peter Van der Stok
Abdur Rashid Sangi
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)