Terminology in Low power And Lossy Networks
draft-ietf-roll-terminology-11

The information below is for an old version of the document
Document Type Active Internet-Draft (roll WG)
Last updated 2013-03-03 (latest revision 2013-02-20)
Replaces draft-vasseur-roll-terminology
Stream IETF
Intended RFC status Informational
Formats pdf htmlized bibtex
Reviews
Stream WG state In WG Last Call
Document shepherd None
IESG IESG state AD Evaluation::Revised I-D Needed
Consensus Boilerplate Unknown
Telechat date
Responsible AD Adrian Farrel
IESG note Michael Richardson (mcr@sandelman.ca) is the document shepherd.
Send notices to roll-chairs@tools.ietf.org, draft-ietf-roll-terminology@tools.ietf.org
Networking Working Group                                     JP. Vasseur
Internet-Draft                                        Cisco Systems, Inc
Intended status: Informational                         February 16, 2013
Expires: August 20, 2013

              Terminology in Low power And Lossy Networks
                   draft-ietf-roll-terminology-11.txt

Abstract

   The documents defines a terminology for discussing routing
   requirements and solutions for networks referred to as Low power and
   Lossy Networks (LLN).  A LLN is typically composed of many embedded
   devices with limited power, memory, and processing resources
   interconnected by a variety of links.  There is a wide scope of
   application areas for LLNs, including industrial monitoring, building
   automation (e.g.  Heating, Ventilating, Air Conditioning, lighting,
   access control, fire), connected home, healthcare, environmental
   monitoring, urban sensor networks, energy management, assets
   tracking, refrigeration.

Requirements Language

   The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT",
   "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this
   document are to be interpreted as described in RFC 2119 [RFC2119].

Status of this Memo

   This Internet-Draft is submitted to IETF in full conformance with the
   provisions of BCP 78 and BCP 79.

   Internet-Drafts are working documents of the Internet Engineering
   Task Force (IETF).  Note that other groups may also distribute
   working documents as Internet-Drafts.  The list of current Internet-
   Drafts is at http://datatracker.ietf.org/drafts/current/.

   Internet-Drafts are draft documents valid for a maximum of six months
   and may be updated, replaced, or obsoleted by other documents at any
   time.  It is inappropriate to use Internet-Drafts as reference
   material or to cite them other than as "work in progress."

   This Internet-Draft will expire on August 20, 2013.

Copyright Notice

   Copyright (c) 2013 IETF Trust and the persons identified as the

Vasseur                  Expires August 20, 2013                [Page 1]
Internet-Draft     draft-ietf-roll-terminology-11.txt      February 2013

   document authors.  All rights reserved.

   This document is subject to BCP 78 and the IETF Trust's Legal
   Provisions Relating to IETF Documents
   (http://trustee.ietf.org/license-info) in effect on the date of
   publication of this document.  Please review these documents
   carefully, as they describe your rights and restrictions with respect
   to this document.  Code Components extracted from this document must
   include Simplified BSD License text as described in Section 4.e of
   the Trust Legal Provisions and are provided without warranty as
   described in the Simplified BSD License.

Table of Contents

   1.  Introduction  . . . . . . . . . . . . . . . . . . . . . . . . . 3
   2.  Terminology . . . . . . . . . . . . . . . . . . . . . . . . . . 3
   3.  IANA Considerations . . . . . . . . . . . . . . . . . . . . . . 7
   4.  Security Considerations . . . . . . . . . . . . . . . . . . . . 7
   5.  Acknowledgements  . . . . . . . . . . . . . . . . . . . . . . . 7
   6.  References  . . . . . . . . . . . . . . . . . . . . . . . . . . 7
     6.1.  Normative References  . . . . . . . . . . . . . . . . . . . 7
     6.2.  Informative References  . . . . . . . . . . . . . . . . . . 7
   Author's Address  . . . . . . . . . . . . . . . . . . . . . . . . . 8

Vasseur                  Expires August 20, 2013                [Page 2]
Internet-Draft     draft-ietf-roll-terminology-11.txt      February 2013

1.  Introduction

   This document defines a terminology for discussing routing
   requirements and solutions for networks referred to as Low power and
   Lossy Networks (LLN).

   Low power and Lossy networks (LLNs) are typically composed of many
   embedded devices with limited power, memory, and processing resources
   interconnected by a variety of links, such as IEEE 802.15.4, Low
   Power WiFi.  There is a wide scope of application areas for LLNs,
   including industrial monitoring, building automation (HVAC, lighting,
   access control, fire), connected home, healthcare, environmental
   monitoring, urban sensor networks, energy management, assets tracking
   and refrigeration.

   Since these applications are usually highly specific (for example
   Industrial Automation, Building Automation, ...), it is not uncommon
   to see a number of disparate terms to describe the same device or
   functionality.  Thus in order to avoid confusion or discrepancies,
   this document specifies the common terminology to be used in all ROLL
   Working Group documents.  The terms defined in this document are used
   in [RFC5548],[RFC5673], [RFC5826] and [RFC5867].

   Terminology specific to a particular application are out of the scope
   of this document.

   It is expected that all routing requirements documents defining
Show full document text