LSP-Ping and BFD encapsulation over ACH
draft-nitinb-mpls-tp-lsp-ping-bfd-procedures-02

Document Type Replaced Internet-Draft (individual)
Last updated 2010-06-04 (latest revision 2010-02-16)
Replaced by draft-ietf-mpls-tp-lsp-ping-bfd-procedures
Stream (None)
Intended RFC status (None)
Formats
Expired & archived
plain text pdf html bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Replaced by draft-ietf-mpls-tp-lsp-ping-bfd-procedures
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-nitinb-mpls-tp-lsp-ping-bfd-procedures-02.txt

Abstract

LSP-Ping and BFD for MPLS are existing and widely deployment OAM mechanisms for MPLS LSPs. This document describes ACH encapsulation for LSP-Ping, to enable use of LSP-Ping when IP addressing is not in use. This document also clarifies the use of BFD for MPLS LSPs using ACH encapsulation, when IP addressing may not be available and/or it may not be desirable to encapsulate BFD packets in IP.

Authors

Nitin Bahadur (nitinb@juniper.net)
Rahul Aggarwal (raggarwa_1@yahoo.com)
David Ward (dward@cisco.com)
Thomas Nadeau (tnadeau@lucidvision.com)
Nurit Sprecher (nurit.sprecher@nsn.com)
Yaacov Weingarten (yaacov.weingarten@nsn.com)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)