MPLS and Ethernet OAM Interworking
draft-ietf-pwe3-mpls-eth-oam-iwk-04

The information below is for an old version of the document
Document Type Expired Internet-Draft (pwe3 WG)
Last updated 2011-03-02 (latest revision 2010-07-12)
Replaces draft-mohan-pwe3-mpls-eth-oam-iwk
Stream IETF
Intended RFC status (None)
Formats
Expired & archived
plain text pdf html
Stream WG state Waiting for WG Chair Go-Ahead
Awaiting Expert Review/Resolution of Issues Raised
Document shepherd Matthew Bocci
IESG IESG state Expired
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-ietf-pwe3-mpls-eth-oam-iwk-04.txt

Abstract

This document specifies the mapping of defect states between Ethernet Attachment Circuits (ACs) and associated Ethernet Pseudowires (PWs) connected in accordance to the PWE3 architecture [RFC3985] to realize an end-to-end emulated Ethernet service. This document augments the mapping of defect states between a PW and associated AC of the end-to-end emulated service in [PW-OAM-MSG- MAP]. In [PW-OAM-MSG-MAP], Ethernet OAM was not covered due to lack of Ethernet OAM maturity. However, since then, [Y.1731] and [802.1ag] have been completed, and this document specifies the mapping of defect states between Ethernet ACs and corresponding Ethernet PWs.

Authors

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)